Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
Circuit diagnosis · Vehicles built from Jun 2009
DESCRIPTION
The stereo jack adapter sends an external device sound signal to the radio receiver through this circuit.The sound signal that has been sent is amplified by the stereo component amplifier or radio receiver, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, radio receiver or speakers.
WIRING DIAGRAM
| for 2GR-FE RHD |


| for Except 2GR-FE RHD |


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO JACK ADAPTER) |
Disconnect the stereo jack adapter and radio receiver connectors.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for 2GR-FE RHD Tester Connection
Condition
Specified Condition
E94-4 (AUXI) - F8-19 (AUXI)
Always
Below 1 Ω
E94-3 (ASGN) - F8-16 (ASGN)
Always
Below 1 Ω
E94-2 (ARO) - F8-15 (ARI)
Always
Below 1 Ω
E94-1 (ALO) - F8-17 (ALI)
Always
Below 1 Ω
E94-5 (AGND) - F8-18 (AGND)
Always
Below 1 Ω
E94-4 (AUXI) - Body ground
Always
10 kΩ or higher
E94-3 (ASGN) - Body ground
Always
10 kΩ or higher
E94-2 (ARO) - Body ground
Always
10 kΩ or higher
E94-1 (ALO) - Body ground
Always
10 kΩ or higher
E94-5 (AGND) - Body ground
Always
10 kΩ or higher
for Except 2GR-FE RHD Tester Connection
Condition
Specified Condition
F44 or F50-4 (AUXI) - F8-19 (AUXI)
Always
Below 1 Ω
F44 or F50-3 (ASGN) - F8-16 (ASGN)
Always
Below 1 Ω
F44 or F50-2 (ARO) - F8-15 (ARI)
Always
Below 1 Ω
F44 or F50-1 (ALO) - F8-17 (ALI)
Always
Below 1 Ω
F44 or F50-5 (AGND) - F8-18 (AGND)
Always
Below 1 Ω
F44 or F50-4 (AUXI) - Body ground
Always
10 kΩ or higher
F44 or F50-3 (ASGN) - Body ground
Always
10 kΩ or higher
F44 or F50-2 (ARO) - Body ground
Always
10 kΩ or higher
F44 or F50-1 (ALO) - Body ground
Always
10 kΩ or higher
F44 or F50-5 (AGND) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
