This circuit is necessary for the ASL (Auto Sound Leveliser) built into the radio receiver. Speed signals are received from the combination meter and used for the ASL. The ASL function automatically adjusts the sound data in order to enable to hear the clear audio sound even when vehicle noise increases (as vehicle noise increases, the volume is turned up etc.).
HINT:
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
If a short occurs in an ECU, all systems in the diagram below will not operate normally.
WIRING DIAGRAM
for 2AZ-FE
for 2GR-FE
INSPECTION PROCEDURE
1. CHECK METER / GAUGE SYSTEM
The circuits that send vehicle speed signals to this system are inspected in the meter system (Click here).
During inspection for the meter section, if there is an instruction that indicates to go back inspections for each system, proceed to the next step.
NEXT
2. CHECK HARNESS AND CONNECTOR (COMBINATION METER - RADIO RECEIVER)
Disconnect the radio receiver connector F8 and combination meter connector F1 or F2.
Measure the resistance according to the value(s) in the table below.