2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

DIAGNOSTIC TROUBLE CODE CHART

Diagnostic trouble codes · Vehicles built from Oct 2006

HINT:
  1. Parameters listed in the chart may be different from your readings depending on the type of instruments used and other factors.
  2. If any DTCs are displayed during a check mode, check the circuit for the DTCs listed below. For details of each DTC, refer to the page indicated.

NOTICE:
Only when the DTCs below are output from the main body ECU, proceed to the pages listed in the "See page" column. If the DTCs are output from the ECUs other than the main body ECU, refer to "HOW TO PROCEED WITH TROUBLESHOOTING" to determine the malfunctioning part.

HINT:
When communication with the ECUs connected to the CAN MS bus is interrupted or a malfunction in the CAN MS bus occurs, the main body ECU detects the malfunctions and outputs DTCs.

CAN MS Bus: 
DTC Code
Detection Item
Trouble Area
See page
B1297
Clearance Sonar ECU Communication Stop
1. Clearance warning ECU power source circuit
2. Clearance warning ECU
3. Wire harness or connector
Click here
B2326
CAN MS Bus Line Communication Malfunction
1. Open or short in CAN MS bus main wire or connector
2. Open or short in CAN MS bus branch wire or connector
3. Clearance warning ECU
4. Main body ECU
5. CAN No. 3 J/C
Click here
← FAIL-SAFE CHART (from Oct 2006)B1297 Clearance Sonar ECU Communication Stop (from Oct 2006) →