2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Speed Signal Circuit

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The windshield wiper relay assembly (auto wiper relay) receives a vehicle speed signal from a combination meter to control an automatic windshield wiper system.
A voltage of 12 V or 5 V is output from the combination meter assembly and then input to the skid control ECU.
A voltage of 12 V or 5 V is output from each ECU or relay and then input to the combination meter assembly.
The signal is changed to a pulse signal at the transistor in the combination meter assembly.
Each ECU controls the respective system based on the pulse signal.
If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.

WIRING DIAGRAM

E136588E01

INSPECTION PROCEDURE


1. CHECK COMBINATION METER SYSTEM
  1. The circuits that send vehicle speed signals to this system are inspected in the meter system (Click here).

  1. During inspection for the meter section, if there is an instruction that indicates to go back inspections for each system, proceed to the next step.


NEXT


2. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - COMBINATION METER)

  1. E138728E03
    Disconnect the windshield wiper relay assembly connectors E26 and combination meter connector F1.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E26-19 (SPD) - F1-11 (+S)
    Always
    Below 1 Ω



NG
Go to step 3
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

3. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - NO. 3 J/B)
  1. Disconnect the 3P and 3J No. 3 J/B connectors.

  1. Measure the resistance according to the value(s) in the table below.E138729E01

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3J-9 - E26-19 (SPD)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - NO. 3 J/B)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (NO. 3 JUNCTION BLOCK)


← Washer Motor Circuit (from Jun 2006)Speed Signal Circuit (Oct 2006 – May 2009) →