P0560 System Voltage
Diagnostic trouble codes · Vehicles built from Oct 2006
DESCRIPTION
The battery supplies electricity to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, these memories are cleared and the TCM determines that there is a malfunction in the power supply circuit. When the engine is next started, the TCM will illuminate the MIL and set the DTC.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0560 |
Open in TCM back-up power source circuit. DTC is detected for 3 sec. or more (1-trip detection logic). |
|
- HINT:
- If DTC P0560 is set, the TCM does not store other DTCs.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT TERMINAL VOLTAGE (BATT VOLTAGE OF TCM) |
Disconnect the TCM connector.

Turn the ignition switch on (IG).
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Specified Condition
BATT (C56-1) - Body ground
10 to 14 V
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (TCM - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection
Specified Condition
E1 (C56-8) - Body ground
Below 1 Ω
|
|
||||
| OK | ||
| ||
