Headlight Signal Circuit
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
DESCRIPTION
The headlight leveling ECU receives the low beam headlights ON signal from the main body ECU.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL J/B - HEADLIGHT LEVELING ECU) |
Disconnect the ID instrument panel J/B assembly connector.

Disconnect the A20 headlight leveling ECU connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
A20-3 (B2) - ID-3 (HRLY)
Always
Below 1 Ω
A20-3 (B2) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
