Sliding Roof Control Switch Circuit
Circuit diagnosis · Vehicles built from Jun 2006
DESCRIPTION
The sliding roof drive gear sub-assembly (sliding roof control ECU) receives slide switch and tilt switch signals and drives its built-in motor.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIDING ROOF OPERATION) |
Select the ACTIVE TEST, use the intelligent tester to generate a control command, and then check that the sliding roof slides open/close and tilts up/down.
- SLIDE ROOF:
Tester Display
Test Part
Control Range
Diagnostic Note
Slide Roof
(Slide Roof)
Operate sliding roof SLIDE CLOSE/TILT UP
CLOS/UP: Sliding roof SLIDE CLOSE or TILT UP operation occurs.
OFF: Sliding roof is not operating
-
Slide Roof
(Slide Roof)
Operate sliding roof SLIDE OPEN/TILT DOWN
OPN/DWN: Sliding roof SLIDE OPEN or TILT DOWN operation occurs
OFF: Sliding roof is not operating
-
- OK:
- Sliding roof operates normally.
|
|
||||
| OK | |
| 2. READ VALUE USING INTELLIGENT TESTER (SLIDING ROOF SWITCH) |
Use the DATA LIST to check if the sliding roof switch is functioning properly.
- SLIDE ROOF:
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Open SW
(Open Switch)
Slide switch open signal/ON or OFF
ON: OPEN switch is pressed.
OFF: OPEN switch is not pressed.
-
Close SW
(Close Switch)
Slide switch close signal/ON or OFF
ON: CLOSE switch is pressed.
OFF: CLOSE switch is not pressed.
-
Up SW
(Up Switch)
Tilt switch up signal/ON or OFF
ON: UP switch is pressed.
OFF: UP switch is not pressed.
-
Down SW
(Down Switch)
Tilt switch down signal/ON or OFF
ON: DOWN switch is pressed.
OFF: DOWN switch is not pressed.
-
- OK:
- The intelligent tester displays as shown in the table according to the operation of each switch.
|
|
||||
| NG | |
| 3. CHECK WIRE HARNESS (SLIDING ROOF CONTROL ECU - ROOF CONSOLE BOX ASSEMBLY) |
Disconnect the Q12 and Q6 connectors.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
Q12-2 (E) - Q6-3 (GND)
Always
Below 1 Ω
Q12-7 (OPN) - Q6-2 (OPN)
Always
Below 1 Ω
Q12-8 (DWN) - Q6-4 (DOWN)
Always
Below 1 Ω
Q12-9 (CLS) - Q6-1 (CLS)
Always
Below 1 Ω
Q12-10 (UP) - Q6-5 (UP)
Always
Below 1 Ω
Q6-1 (CLS) - Body ground
Always
10 kΩ or higher
Q6-2 (OPN) - Body ground
Always
10 kΩ or higher
Q6-3 (GND) - Body ground
Always
Below 1 Ω
Q6-4 (DOWN) - Body ground
Always
10 kΩ or higher
Q6-5 (UP) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
