When any DTC of the CAN communication system is output, first measure the resistance between the terminals of the DLC3 to confirm the trouble area.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Turn the ignition switch off before measuring the resistance of the CAN main wire and CAN branch wires.
After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
HINT:
Operating the ignition switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
1. CHECK CAN BUS WIRE (MAIN BUS WIRE FOR DISCONNECTION, BUS WIRES FOR SHORT CIRCUIT)
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.