HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
- NOTICE:
- DTCs for the CAN communication system are as follows: U0101, U0073, U0100, U0123*1, U0124*1, U0126*1, U0129, B1297*2, B2326*2 and B1499.
*1: with VSC
*2: with TOYOTA parking assist-sensor system
- Refer to troubleshooting of each system if DTCs regarding the CAN communication system are not output.
- DTCs for the CAN communication system are as follows: U0101, U0073, U0100, U0123*1, U0124*1, U0126*1, U0129, B1297*2, B2326*2 and B1499.
| 1.CHECK AND CLEAR DTCS |
| |||||
| 2.CHECK FOR INSTALLED SYSTEMS (ECUS & SENSORS) THAT ADOPT CAN COMMUNICATION |
Check which of the following is adopted: Clearance sonar system (with corner sensor), VSC system (Click here).
| |||||
| 3.CHECK CAN BUS LINE |
Check the CAN Bus Line (Click here).
| |||||
| 4.CHECK COMMUNICATION BUS |
Select "Communication Bus Check" (Click here).
- Result:
Symptom
Proceed to
All the ECUs and sensors connected to the CAN communication system are displayed on the screen.
A
An ECU or sensor not connected to the CAN communication system is displayed on the screen.
B*
More than one of the ECUs and sensors not connected to the CAN communication system are displayed on the screen. (If the displayed ECUs and sensors are only those relating to the "Engine" and "ECT", proceed to B.)
C
- All ECUs and sensors except the main body ECU connected to the CAN MS bus are not displayed on the screen.
- The main body ECU outputs DTC B2326.
D
All ECUs and sensors connected to the CAN MS bus are not displayed on the screen.
(Open in main body ECU branch wire or main body ECU malfunction)
E
- All ECUs and sensors except the main body ECU connected to the CAN MS bus are not displayed on the screen.
- NOTICE:
- The systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle and option settings. Check which systems (ECUs, sensors) are installed on the vehicle (Click here).
- Non-installed ECUs or sensors are not displayed. Do not mistake ECUs that are not installed as being in communication stop mode.
- If 2 or more ECUs or sensors are not displayed on the intelligent tester, perform troubleshooting for communication stop mode for each undisplayed ECU or sensor. (Open in one side of the CAN branch wires.)
- The systems (ECUs, sensors) that adopt CAN communication vary depending on the vehicle and option settings. Check which systems (ECUs, sensors) are installed on the vehicle (Click here).
- HINT:
- *: See the "DTC CHART" instead of the "COMMUNICATION STOP MODE TABLE", when some of the ECUs connected to the CAN MS bus are not displayed on the screen.
|
|||||
|
|||||
|
|||||
|
|||||
| |||||
| 5.DTC COMBINATION TABLE |
Confirm trouble according to the combination of output DTCs regarding the CAN communication system (Click here).
- HINT:
- Previous CAN communication system DTCs may be the cause if CAN communication system DTCs are output and all ECUs and sensors connected to the CAN communication system are displayed on the intelligent tester "Communication Bus Check" screen.
| |||||
| 6.CIRCUIT INSPECTION |
| |||||
| 7.IDENTIFICATION OF PROBLEM |
| |||||
| 8.REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
| |||||