2006-2011 Camry Aurion · Service Manual RESTRAINTS

SRS Warning Light does not Come ON

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

Click here.

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE


1. CHECK BATTERY
  1. Measure the voltage of the battery.

    Standard voltage:
    11 to 14 V



NG
CHECK AND REPLACE BATTERY OR CHARGING SYSTEM
OK


2. CHECK CONNECTOR
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Check that the connector is properly connected to the combination meter assembly.

    OK:
    The connectors is properly connected.



NG
CONNECT CONNECTOR PROPERLY
OK


3. CHECK WIRE HARNESS (COMBINATION METER ASSEMBLY - BODY GROUND)

  1. E134491E02
    Turn the ignition switch to the LOCK position.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Disconnect the F1 connector from the combination meter assembly.

  1. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    F1-1 (B) - Body ground
    Always
    10 to 14 V
    F1-13 (IG+) - Body ground
    Ignition switch ON
    10 to 14 V

  1. Turn the ignition switch to the LOCK position.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F1-12 (E2) - Body ground
    Always
    Below 1 Ω
    F1-24 (ES) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS (COMBINATION METER ASSEMBLY - BODY GROUND)
OK


4. CHECK SRS WARNING LIGHT
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Connect the connector to the combination meter assembly.

  1. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

  1. Turn the ignition switch to the ON position.

  1. Check the SRS warning light condition.

    OK:
    After the primary check period, the SRS warning light goes off for approximately 10 seconds, and then remains on.

    HINT:
    The primary check period is approximately 6 seconds after the ignition switch is turned ON.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)


← SRS Warning Light Remains ON (from Jun 2009)SRS Warning Light does not Come ON (Oct 2006 – May 2009) →