2006-2011 Camry Aurion · Service Manual BRAKE

Slip Indicator Light Remains ON

Circuit diagnosis · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The skid control ECU is connected to the combination meter assembly via CAN communication.
The SLIP indicator light blinks during VSC and/or TRC operation.
When the system fails, the SLIP indicator light comes on to warn the driver (Click here).

WIRING DIAGRAM

C145720E05

INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2. CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED
  1. Check if the skid control ECU connector is securely connected.

    OK:
    The connector is securely connected.



NG
CONNECT CONNECTOR TO ECU CORRECTLY
OK


3. CHECK BATTERY
  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V



NG
INSPECT CHARGING SYSTEM (Click here)
OK


4. INSPECT COMBINATION METER ASSEMBLY
  1. Connect the intelligent tester to the DLC3.

  1. Select the "Active Test" on the tester (Click here).

    Active Test: ABS/TRC/VSC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Slip Indicator Lamp
    Slip indicator light
    Indicator light ON/OFF
    Observe combination meter

  1. Check SLIP indicator light operation.

    OK:
    The SLIP indicator light turns on or off in accordance with the intelligent tester.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← Brake Warning Light does not Come ON (from Jun 2009)Slip Indicator Light Remains ON (Oct 2006 – May 2009) →