2006-2011 Camry Aurion · Service Manual BRAKE

Slip Indicator Light does not Come ON

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The skid control ECU is connected to the combination meter assembly via CAN communication.
The SLIP indicator light blinks during VSC and/or TRC operation.
When the system fails, the SLIP indicator light comes on to warn the driver (Click here).

WIRING DIAGRAM

C225724E05
C225724E06

INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:
    Result
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2. INSPECT COMBINATION METER ASSEMBLY
  1. Connect the intelligent tester to the DLC3.

  1. Select the "Active Test" on the tester (Click here).

    Active Test: ABS/TRC/VSC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Slip Indicator Lamp
    Slip indicator light
    Indicator light ON/OFF
    Observe combination meter

  1. Check the SLIP indicator light operation.

    OK:
    The SLIP indicator light turns on or off in accordance with the intelligent tester.



NG
REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)


← Slip Indicator Light does not Come ON (Oct 2006 – May 2009)Skid Control Buzzer Circuit (Jun 2006 – Sep 2006) →