2006-2011 Camry Aurion · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING

  1. C144664
    Install the front shock absorber with coil spring to the front axle assembly and insert the 2 bolts from the rear of the vehicle.

  1. C132410E01
    Slowly jack up the vehicle using a wooden block and install the front shock absorber with coil spring (upper side) to the vehicle.

  1. C132415
    Install the 3 nuts to the upper side of the front shock absorber with coil spring.

    Torque:
    85 N*m{ 867 kgf*cm , 63 ft.*lbf }

  1. C132414
    Install the 2 nuts to the lower side of the front shock absorber with coil spring.

    Torque:
    210 N*m{ 2,140 kgf*cm , 155 ft.*lbf }

    NOTICE:
    When installing the nuts, keep the bolts from rotating.

  1. C132413
    Install the front flexible hose and front speed sensor wire harness with the bolt to the shock absorber with coil spring.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    NOTICE:
    Do not twist the front speed sensor wire harness when installing it.

  1. C132412
    Fully tighten the lock nut.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }


2. INSTALL FRONT STABILIZER LINK ASSEMBLY

  1. C144427E03
    Install the front stabilizer link assembly with the nut to the front shock absorber with coil spring.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.


3. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }


4. CHECK ABS SPEED SENSOR SIGNAL

HINT:
  1. ABS: Click here
  2. VSC: Click here


5. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← INSTALLATION (Jun 2006 – Sep 2006)INSTALLATION (from Jun 2009) →