TERMINALS OF ECU
System information · Vehicles built Oct 2006 – May 2009
| TELEVISION CAMERA ASSEMBLY |
Disconnect the S17 camera connector.


Measure the voltage and resistance between each terminal of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Value
CGND (S17-3) - Body ground
W - Body ground
Ground
Always
Below 1 Ω
CB+ (S17-4) - CGND (S17-3)
B - W
Power source
Engine switch on (IG), shift lever R position
5.50 to 7.05 V
Reconnect the S17 camera connector.
Measure the voltage and frequency between each terminal of the connector.
If the result is not as specified, the camera may have a malfunction.Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Value
CV+ (S17-2) - CV- (S17-1)
R - Shielded
Display signal
Engine switch on (IG), shift lever R position
See waveform 1
Reference:

Oscilloscope waveformWaveform 1
Item
Content
Measurement terminal
CV+ - CV-
Measurement setting
0.2 V/DIV., 0.2 μS/DIV.
Condition
Engine switch on (IG), Shift lever R position
| NAVIGATION RECEIVER (Click here) |