2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Reverse Signal Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

DESCRIPTION

The navigation receiver assembly receives a reverse signal from the park/neutral position switch.

WIRING DIAGRAM

E131097E08

INSPECTION PROCEDURE


1. CHECK BACK-UP LIGHT
  1. Move the shift lever to the R position and check if the back-up light comes on.

    OK:
    The back-up light comes on.



NG
GO TO LIGHTING SYSTEM
OK


2. CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)

  1. E132815
    Enter the "Display Check" mode (Vehicle Signal Check Mode) (Click here).

  1. Check that the display changes between ON and OFF according to the shift lever operation (P and R).

    OK:
    Shift Lever Position
    Display
    R
    ON
    Except R
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


3. INSPECT NAVIGATION RECEIVER ASSEMBLY

  1. E137752E02
    Disconnect the navigation receiver connector F13.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    REV (F13-5) - Body ground
    Engine switch is on (IG).
    Shift lever is moved to R position.
    10 to 14 V
    REV (F13-5) - Body ground
    Engine switch is on (IG).
    Shift lever is moved to any position except R.
    Below 1 V



OK
REPLACE NAVIGATION RECEIVER ASSEMBLY
NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH)


← TERMINALS OF ECU (Oct 2006 – May 2009)Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly (Oct 2006 – May 2009) →