The unlock warning switch detects if the key is in the ignition key cylinder. The unlock warning switch turns on when the key is inserted into the ignition key cylinder and turns off when the key is removed from the cylinder. The main body ECU (instrument panel J/B) is connected to the unlock warning switch via terminal KSW and key detection status signals are input to the main body ECU (instrument panel J/B). The main body ECU (instrument panel J/B) applies voltage to the unlock warning switch via terminal KSW. When the unlock warning switch is on (there is continuity between the switch terminals), a signal indicating that the key is in the ignition key cylinder is input to the main body ECU (instrument panel J/B). When the switch is off (there is no continuity between the switch terminals), a signal indicating that the key is not in the cylinder is input.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. READ VALUE USING INTELLIGENT TESTER
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Select Key Unlock Warning SW in the Data List and read the tester display.
BODY:
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Key Unlock Warning SW
Unlock warning switch signal /ON or OFF
ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder
-
OK:
ON (Key is in ignition key cylinder) appears on the screen.
OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
NG
2. INSPECT UNLOCK WARNING SWITCH ASSEMBLY
Remove the unlock warning switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.