U0100 Lost Communication with ECM / PCM "A"
Diagnostic trouble codes · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The engine control unit intercommunicates with the TCM using the Controller Area Network (CAN).If there is a problem in this intercommunication, the TCM sets a DTC.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| U0100 |
|
TCM |
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- If the CAN communication malfunctions, the TCM cannot receive the current data from the ECM. In this case, the freeze frame data output from the TCM have not been updated, so the data will not be useful for the inspection. However, reading the Data List as the first step in troubleshooting is effective to find malfunctions.
- If the CAN communication malfunctions, the TCM cannot receive the current data from the ECM. In this case, the freeze frame data output from the TCM have not been updated, so the data will not be useful for the inspection. However, reading the Data List as the first step in troubleshooting is effective to find malfunctions.
| 1. CHECK ECU TERMINAL VOLTAGE (+B AND E1 TERMINALS) |
Disconnect the TCM connector.

Turn the ignition switch on (IG).
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
Specified Condition
C56-18 (+B) - Body ground
9 to 14 V
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Specified Condition
C56-8 (E1) - Body ground
Below 1 Ω
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (TCM - ECM) |
Disconnect the C56 TCM connector.

Disconnect the C58*1 or C55*2 ECM connector.*1: for RHD*2: for LHD
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Specified Condition
C56-6 (CAN+) - C58-2*1 (CAN+)
Below 1 Ω
C56-6 (CAN+) - C55-2*2 (CAN+)
Below 1 Ω
C56-7 (CAN-) - C58-1*1 (CAN-)
Below 1 Ω
C56-7 (CAN-) - C55-1*2 (CAN-)
Below 1 Ω
C56-6 (CAN+) or C58-2*1 (CAN+) - Body ground
1 MΩ or more
C56-6 (CAN+) or C55-2*2 (CAN+) - Body ground
1 MΩ or more
C56-7 (CAN-) or C58-1*1 (CAN-) - Body ground
1 MΩ or more
C56-7 (CAN-) or C55-1*2 (CAN-) - Body ground
1 MΩ or more
|
|
||||
| OK | |
| 3. CHECK IF DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Clear the DTC.
Replace the TCM.
- HINT:
- Replace the TCM with the TCM of a normally functioning vehicle of the same model.
Start the engine.
Read the DTCs.
- Result:
Display (DTC Output)
Proceed to
P0100
A
No DTC
B
|
|
||||
| A | ||
| ||
