2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Meter Illumination does not Dim at Night

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The meter CPU receives auto dimmer signals from the main body ECU via the CAN communication lines (CAN No. 1 Bus). When the meter CPU receives an auto dimmer signal, it dims the meter illumination. The main body ECU determines whether it is daytime, twilight, or nighttime based on the waveform transmitted from the automatic light control sensor. If the main body ECU determines that it is daytime, the ECU does not send auto dimmer signals. Therefore, the meter illumination (warning and indicator lights) will not dim even if the driver accidentally turns the light control switch to the TAIL or HEAD position in daytime.

HINT:
When the meter illumination does not dim at night, the light control rheostat is in the tail cancel position, or there may be a malfunction in the automatic light control sensor, main body ECU, CAN communication system, wire harness or connector, or combination meter assembly.


WIRING DIAGRAM


for Automatic A/C
E118069E10

for Manual A/C
E118069E15

INSPECTION PROCEDURE


1. CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication DTC is output (Click here for LHD without Smart Entry and Start System, Click here for LHD with Smart Entry and Start System, Click here for RHD without Smart Entry and Start System, Click here for RHD with Smart Entry and Start System).

    Result:
    Result
    Proceed to
    CAN communication DTC is not output.
    A
    CAN communication DTC is output.
    B (Click here for LHD without Smart Entry and Start System, Click here for LHD with Smart Entry and Start System, Click here for RHD without Smart Entry and Start System, Click here for RHD with Smart Entry and Start System)



B
GO TO CAN COMMUNICATION SYSTEM
A


2. CHECK DTC
  1. Check if DTC B1244 is output (Click here (for 2GR-FE), Click here (for 2AZ-FE)).

    Result:
    Result
    Proceed to
    B1244 is not output.
    A
    B1244 is output (for 2GR-FE).
    B (Click here )
    B1244 is output (for 2AZ-FE).
    B (Click here)



B
GO TO LIGHTING SYSTEM
A


3. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the tester ON.

  1. Turn the light control switch to the TAIL/HEAD position.

  1. Enter the following menus: Body / Main Body / Active Test.

  1. Check the meter illumination.

    Main Body: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Dimmer Sig
    Auto dimmer signal
    Auto dimmer signal ON/OFF
    -

    OK:
    The meter illumination is dimmed when the Dimmer Sig is ON.

    HINT:
    Refer to the sensitivity setting in the customization table of the automatic light control system. (Click here)



NG
Go to step 4
OK

CHECK LIGHTING SETTING

4. REPLACE COMBINATION METER ASSEMBLY
  1. Replace the combination meter assembly with a new or a normal one.

    OK:
    The operation of the combination meter assembly returns to normal.



NG
REPLACE MAIN BODY ECU
OK

END


← Meter Illumination does not Dim at Night (Oct 2006 – May 2009)Speed Signal Circuit (Jun 2006 – Sep 2006) →