The navigation receiver assembly receives a reverse signal from the park/neutral position switch and information about the GPS antenna, and then adjusts the vehicle position on the navigation display.
WIRING DIAGRAM
INSPECTION PROCEDURE
1. INSPECT NAVIGATION RECEIVER ASSEMBLY
Disconnect the F13 navigation receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Condition
Specified Condition
F13-5 (REV) - Body ground
Ignition switch on (IG) Shift lever in R
11 to 14 V
F13-5 (REV) - Body ground
Ignition switch on (IG) Shift lever in any position except R
Below 1 V
Result:
Result
Proceed to
OK
A
NG (for 2GR-FE RHD)
B
NG (except 2GR-FE RHD)
C
Text in Illustration
*1
Front view of wire harness connector (to Navigation Receiver Assembly)