2006-2011 Camry Aurion · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. REMOVE BRAKE BOOSTER ASSEMBLY

HINT:
Refer to the procedures up to "REMOVE BRAKE BOOSTER". (Click here)


2. REMOVE FRONT DOOR SCUFF PLATE LH

  1. B132067
    Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.


3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

  1. B132116E01
    Remove the cowl side trim clip.

  1. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.


4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH

  1. B147264E01
    Remove the bolt <A> and the screw <B>.

  1. Disengage the 2 claws and the DLC3.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the claw and the 4 clips.

  1. Remove the air hose, disconnect the connector, and then remove the lower No. 1 instrument panel finish panel.


5. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for LHD)

  1. B149938
    Disengage the 3 claws and the 2 clips.

  1. Disconnect each connector and remove the No. 1 instrument panel sub-assembly.


6. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for RHD)

  1. B149936
    Disengage the 3 claws and the 2 clips.

  1. Disconnect the connector and remove the No. 1instrument panel sub-assembly.


7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL

  1. B144612
    Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.


8. REMOVE INSTRUMENT CLUSTER FINISH PANEL

  1. B133985E01
    Remove the 2 clips.

  1. Disengage the guide and 4 claws, and then remove the instrument cluster finish panel sub-assembly.


9. REMOVE COMBINATION METER ASSEMBLY

  1. B152781E01
    Remove the 4 screws <E>.

  1. Disconnect each connector and remove the combination meter assembly.


10. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY (for LHD)

  1. C132710E01
    Disconnect the stop light switch connector and disengage the 2 clamps.

  1. C132711E01
    Remove 2 bolts (A), bolt (B) and the No. 1 brake pedal support plate.

  1. C132712
    Remove the bolt and the brake pedal support assembly.


11. REMOVE ACCELERATOR PEDAL ASSEMBLY (for RHD)

  1. A135676
    Disconnect the accelerator pedal position sensor connector.

  1. Remove the 2 bolts and accelerator pedal assembly.


12. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY (for RHD)

  1. C133309
    Disconnect the stop light switch connector.

  1. C132837E02
    Remove 2 bolts (A), bolt (B) and the No. 1 brake pedal support plate.

  1. C132836E02
    Remove the bolt and brake pedal support assembly, and disengage the clamp.

← COMPONENTS (from Jun 2009)REMOVAL (Oct 2006 – May 2009) →