INSTALLATION
Removal / installation · Vehicles built Jun 2006 – Sep 2006
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
INSTALL YAW RATE AND ACCELERATION SENSOR |
 |
- Install the yaw rate and acceleration sensor to the bracket with the 2 nuts.
-
Torque:
- 5.0 N*m{
51 kgf*cm
, 44 in.*lbf
}
- Install the yaw rate and acceleration sensor with the 2 bolts.
- NOTICE:
- Do not damage the yaw rate or acceleration sensor.
- Make sure that the yaw rate and acceleration sensor is installed securely.
-
Torque:
- 13 N*m{
133 kgf*cm
, 10 ft.*lbf
}
Connect the yaw rate and acceleration sensor connector.
| 2.
INSTALL CONSOLE BOX ASSEMBLY |
 |
- HINT:
- Refer to the procedures up to "INSTALL REAR CONSOLE BOX". (Click here)
| 3.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
|
| 4.
INSPECT SENSOR SIGNAL |
 |
- HINT:
- (Click here)
| 5.
CHECK FOR DTC AND CLEAR |
 |
- HINT:
- (Click here)