2006-2011 Camry Aurion · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL YAW RATE AND ACCELERATION SENSOR

  1. C145964
    Install the yaw rate and acceleration sensor to the bracket with the 2 nuts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. C145963
    Install the yaw rate and acceleration sensor with the 2 bolts.

    NOTICE:
    1. Do not damage the yaw rate or acceleration sensor.
    2. Make sure that the yaw rate and acceleration sensor is installed securely.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }

  1. Connect the yaw rate and acceleration sensor connector.


2. INSTALL CONSOLE BOX ASSEMBLY

HINT:
  1. Refer to the procedures up to "INSTALL REAR CONSOLE BOX". (except 2GR-FE RHD Click here)
  2. Refer to the procedures up to "INSTALL REAR CONSOLE BOX". (for 2GR-FE RHD Click here)


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

4. INSPECT SENSOR SIGNAL

HINT:
(Click here)


5. CHECK FOR DTC AND CLEAR

HINT:
(Click here)

← INSTALLATION (Jun 2006 – Sep 2006)INSTALLATION (from Jun 2009) →