2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

HINT:
Refer to the procedure up to Remove Instrument Panel Safety Pad Assembly (Click here).


2. REMOVE SIDE NO. 1 DEFROSTER NOZZLE DUCT

  1. B158950
    Remove the screw <H> and the side No. 1 defroster nozzle duct.


3. REMOVE SIDE NO. 2 DEFROSTER NOZZLE DUCT

  1. B158951
    Remove the screw <H> and the side No. 2 defroster nozzle duct.


4. REMOVE DEFROSTER NOZZLE ASSEMBLY

  1. B158952
    Remove the 3 screws <H> and the defroster nozzle assembly.


5. REMOVE NO. 1 HEATER TO REGISTER DUCT

  1. B158953
    Remove the 3 screws <H> and the No. 1 heater to register duct.


6. REMOVE NO. 3 HEATER TO REGISTER DUCT

  1. B158954
    Remove the 3 screws <H> and the No. 3 heater to register duct.


7. REMOVE NO. 2 HEATER TO REGISTER DUCT

  1. B158955
    Remove the 2 screws <H> and the No. 2 heater to register duct.


8. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY

  1. Disengage the 6 clamps and clip and remove the No. 2 antenna cord sub-assembly.

    E194904


9. REMOVE ROOF HEADLINING ASSEMBLY

HINT:
Refer to the procedure up to Remove Roof Headlining Assembly (Click here).


10. REMOVE ANTENNA CORD SUB-ASSEMBLY
  1. Peel the strips of the tape used to secure the antenna cord only to the extent that allows removal of the antenna cord.

    HINT:
    Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.

  1. Remove the antenna cord from the roof headlining.

    E194900E01

← REMOVAL (Oct 2006 – May 2009)INSTALLATION (Oct 2006 – May 2009) →