2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

U0129 Lost Communication with Skid Control ECU

Diagnostic trouble codes · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The combination meter assembly communicates with the skid control ECU via the CAN communication lines (CAN No. 1 Bus).
DTC No.
DTC Detection Conditions
Trouble Areas
U0129
When IG voltage is 9.5 V or more and the following condition is detected:
  1. No communication with skid control ECU continues for 3 seconds or more
  1. Skid control ECU
  2. CAN communication system

WIRING DIAGRAM

E124226E13

INSPECTION PROCEDURE


1. CONFIRM DTC OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Ignition switch on (IG).

  1. Turn the tester on.

  1. Clear the stored DTCs by selecting the following menu items on the tester: Body / Combination Meter / DTC Info / Clear Codes.

  1. Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.

  1. Stop the vehicle.

  1. Check for DTCs (Click here for LHD without Smart Entry and Start System, Click here for LHD with Smart Entry and Start System, Click here for RHD without Smart Entry and Start System, Click here for RHD with Smart Entry and Start System).

    Result:
    Result
    Proceed to
    DTC is output.
    A (Click here for LHD without Smart Entry and Start System, Click here for LHD with Smart Entry and Start System, Click here for RHD without Smart Entry and Start System, Click here for RHD with Smart Entry and Start System)
    DTC is not output.
    B



B
USE SIMULATION METHOD TO CHECK
A

GO TO CAN COMMUNICATION SYSTEM


← U0129 Lost Communication with Skid Control ECU (Oct 2006 – May 2009)Entire Combination Meter does not Operate (Jun 2006 – Sep 2006) →