Vehicle Battery Voltage
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
Battery voltage is applied to the mayday ECU terminal 3. If the battery voltage falls below a preset voltage for longer than 30 minutes, the mayday ECU will transmit a Low Battery alert to the Toyota Link Call Centre.If the battery is removed, the mayday ECU will transmit a Low Battery alert to the Toyota Link Call Centre.
For further information, refer to ALERTS - Low Battery Voltage Alert (Click here).
INSPECTION PROCEDURE
| 1. CHECK BATTERY VOLTAGE |
Using a digital multimeter, measure the vehicle battery voltage.
- OK:
- 12 - 14 V
|
|
||||
| OK | |
| 2. CHECK BATTERY VOLTAGE USING TDT |
Check battery voltage using the TDT.
Using the TDT, select: System Menu / Diagnosis / Data List.
Scroll to Vehicle Battery Voltage.
- OK:
- 12 - 14 V
|
|
||||
| NG | |
| 3. CHECK BATTERY VOLTAGE AT MAYDAY ECU |
Connect a digital multimeter between mayday ECU unit connector N46 terminal 3 and ground.

Check for voltage.
- OK:
- 12 - 14 V
|
|
||||
| NG | |
| 4. CHECK THE VOLTAGE AT THE MAYDAY FUSE |
Connect a digital multimeter between the MAYDAY/TEL fuse and ground.
Measure the voltage.
- OK:
- 12 - 14 V
|
|
||||
| NG | ||
| ||
| 5. CHECK MAYDAY ECU GROUND |
Connect a digital multimeter between mayday ECU unit connector N46 terminal 4 and ground.

Check for continuity.
- OK:
- Less than 1 Ω
|
|
||||
| OK | |
| 6. CHECK MAYDAY ECU WIRE HARNESS |
Disconnect the mayday ECU connectors A and B.

Check for continuity between the mayday ECU unit connector N46 and connectors A and B.
- OK:
- Less than 1 Ω
|
|
||||
| OK | |
| 7. CHECK MAYDAY ECU CONNECTORS |
Are the mayday ECU connectors tight?
|
|
||||
| YES | ||
| ||
