REMOVAL
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| 1. PLACE MAYDAY ECU IN SERVICE MODE |
Using the diagnostic tool, place the mayday ECU into Service mode, refer to TDT System Functions (Click here).
| 2. DISCONNECT BATTERY |
Disconnect the negative battery cable from the battery.
| 3. REMOVE REAR SUNSHADE ASSEMBLY (w/ Rear Sunshade) |
- HINT:
- Follow the steps for removing the rear sunshade assembly (Click here).
| 4. REMOVE MAYDAY ECU UNIT |
Disconnect the mayday ECU unit connector N46, GPS antenna connector and GSM antenna connector.
- NOTICE:
- Support the mayday ECU unit.
Remove the 3 nuts.
Remove the mayday ECU unit.
Remove the 3 reinforcement plates.
