2007 Aurion TRD · Service Manual Engine Mechanical

Rear VVT OIL Pipe

Engine Mechanical

COMPONENTS
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3. REMOVE FRONT WHEEL RH
4. REMOVE FRONT FENDER APRON SEAL RH
5. REMOVE COOL AIR INTAKE DUCT SEAL ( Click Here )
6. REMOVE V-BANK COVER SUB-ASSEMBLY ( Click Here )
7. REMOVE ENGINE MOUNTING STAY ( Click Here )
8. REMOVE ENGINE MOVING CONTROL ROD SUB-ASSEMBLY ( Click Here )
9. REMOVE V-RIBBED BELT ( Click Here )
10. SEPARATE VANE PUMP ASSEMBLY
(a) Disconnect the power steering fluid pressure switch connector.
-
(b) Using SST, loosen bolt (A) and remove bolt (B) and move the vane pump assembly to one side.
SST
09249-63010
-
11. REMOVE REAR VVT OIL PIPE
(a) Remove the lower bolt and the oil pipe union and gasket.
-
(b) Remove the upper bolt and the oil pipe union with the oil control valve filter and 2 gaskets.
-
(c) Remove the rear VVT oil pipe.
-
INSTALLATION
1. INSTALL REAR VVT OIL PIPE
(a) Locate the rear VVT oil pipe.
-
(b) Fit the upper bolt and gasket into the oil pipe union. Fit the second gasket and the oil control valve filter onto the bolt.
-
(c) Install the oil pipe union into the cylinder head cover and hand tighten.
-
(d) Using SST, hold the oil pipe union in position and tighten the upper bolt.
SST
SR-1142
Torque:
65 N*m (663 kgf*cm, 48 ft.*lbf)
-
(e) Fit the lower bolt and gasket into the oil pipe union.
-
(f) Install the oil pipe union into the rear of the cylinder head and tighten.
Torque:
65 N*m (663 kgf*cm, 48 ft.*lbf)
-
2. INSTALL VANE PUMP ASSEMBLY
(a) Install the vane pump assembly with bolt (B) and (A).
-
(b) Using SST, tighten the bolts.
SST
09249-63010
Torque:
29 N*m (294 kgf*cm, 21 ft.*lbf)
-
(c) Connect the power steering fluid pressure switch connector.
-
3. INSTALL V-RIBBED BELT ( Click Here )
4. INSTALL ENGINE MOVING CONTROL ROD SUB-ASSEMBLY ( Click Here )
5. INSTALL ENGINE MOUNTING STAY ( Click Here )
6. INSTALL V-BANK COVER SUB-ASSEMBLY ( Click Here )
7. INSTALL COOL AIR INTAKE DUCT SEAL ( Click Here )
8. INSTALL FRONT FENDER APRON SEAL RH
9. INSTALL FRONT WHEEL RH
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL