2007 Aurion TRD · Service Manual Suspension

Rear Wheel Alignment

Suspension

ADJUSTMENT
1. INSPECT TYRES ( Click Here )
2. MEASURE VEHICLE HEIGHT ( Click Here )
3. INSPECT TOE-IN
(a) Bounce the vehicle up and down at the corners to stabilise the suspension. Inspect the toe-in.
Toe-in
—
C - D:
1 +-0.5 mm (0.04 +- 0.02 in.)
If the toe-in is not within the specified range, inspect the suspension parts and replace them if necessary.
-
4. ADJUST TOE-IN
(a) Measure the lengths of the right and left rear No. 2 suspension arms.
Difference in the length between the right and left rear No. 2 suspension arms:
1.5 mm (0.06 in.) or less
If the left-right difference is larger than 1.5 mm (0.06 in.), adjust it by following the procedures below.
-
(b) Loosen the lock nuts.
-
(c) Turn the right and left adjusting tubes by an equal amount to adjust toe-in.
HINT:
• Try to adjust toe-in to the centre of the specified range.
• One turn of each adjusting tube will adjust toe-in by approximately 10.8 mm (0.425 in.).
-
(d) Tighten the lock nuts.
Torque:
56 N*m (571 kgf*cm, 41 ft.*lbf)
-
5. INSPECT CAMBER