Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System)

ENGINE IMMOBILISER SYSTEM (w/ Entry and Start System) > DIAGNOSTIC TROUBLE CODE CHART

for Preparation Click here


HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.


CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) DIAGNOSTIC TROUBLE CODE CHART

Certification ECU (Smart Key ECU Assembly) 
DTC Code
Detection Item
Trouble Area
See page
B2784
Antenna Coil Open / Short
1. Wire harness or connector
2. Engine switch
3. Certification ECU (Smart key ECU assembly)
Click here
B278A
Short to GND in Immobiliser System Power Source Circuit
1. Wire harness or connector
2. Engine switch
3. Certification ECU (Smart key ECU assembly)
Click here
B2790
ID BOX EEPROM Malfunction
1. ID code box (Immobiliser code ECU)
2. Certification ECU (Smart key ECU assembly)
Click here

ECM DIAGNOSTIC TROUBLE CODE CHART

HINT:
The DTCs for the engine immobiliser system are specified above. If the other codes are output, check the DTC chart for the SFI system.


ECM 
DTC Code
Detection Item
Trouble Area
See page
B2799
Engine Immobiliser System Malfunction
1. Wire harness or connector
2. ECM
3. ID code box (Immobiliser code ECU)
Click here