Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM (for RHD)

CAN COMMUNICATION SYSTEM (for RHD) > PROBLEM SYMPTOMS TABLE

for Preparation Click here



RESULT LIST OF HOW TO PROCEED WITH TROUBLESHOOTING: 
Symptom
Suspected Area
See page
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Open in CAN Main Bus Wire"
Open in CAN Main Bus Wire
Click here
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short in CAN Bus Wires"
Short in CAN Bus Wires
Click here
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short to +B in CAN Bus Wire"
Short to B+ in CAN Bus Wire
Click here
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Short to GND in CAN Bus Wire"
Short to GND in CAN Bus Wire
Click here
The result of "HOW TO PROCEED WITH TROUBLESHOOTING" is "Open in One Side of CAN Sub Bus Wire"
Open in One Side of CAN Branch Wire
Click here

COMMUNICATION STOP MODE TABLE: 
Symptom
Suspected Area
See page
"ABS/VSC/TRAC" is not displayed on the intelligent tester (with VSC)
Skid Control ECU Communication Stop Mode
Click here
"A/C" is not displayed on the intelligent tester
Air Conditioning Amplifier Communication Stop Mode
Click here
"Body/Gateway" is not displayed on the intelligent tester
Main Body ECU Communication Stop Mode
Click here
"Steering Angle Sensor" is not displayed on the intelligent tester
Steering Angle Sensor Communication Stop Mode*
Click here
"Yaw Rate/Deceleration Sensor" is not displayed on the intelligent tester
Yaw Rate Sensor Communication Stop Mode*
Click here
"Engine" is not displayed on the intelligent tester
ECM Communication Stop Mode
Click here
"Meter" is not displayed on the intelligent tester
Combination Meter Communication Stop Mode
Click here
"SRS Airbag" is not displayed on the intelligent tester
Center Airbag Sensor Communication Stop Mode
Click here