POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows) > Driver Side Power Window does not Operate with Power Window Master Switch |

| 1.READ VALUE USING INTELLIGENT TESTER (Main Body) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Communication D-Door Motor | Connection status between power window regulator motor (for driver side) and main body ECU (instrument panel J/B) / OK or STOP | OK: Normal communication STOP: Communication stopped | - |
|
| ||||
| OK | |
| 2.READ VALUE USING INTELLIGENT TESTER (D-Door Motor) |
Enter the following menus: Body / D-Door Motor / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D Door P/W Up SW | Driver side power window manual up switch signal / ON or OFF | ON: Driver door power window manual up switch operated OFF: Driver door power window manual up switch not operated | - |
| D Door P/W Down SW | Driver side power window manual down switch signal / ON or OFF | ON: Driver door power window manual down switch operated OFF: Driver door power window manual down switch not operated | - |
|
| ||||
| OK | |
| 3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (D-Door Motor) |
Enter the following menus: Body / D-Door Motor / Active Test.
Perform the Active Test according to the display on the intelligent tester.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Power Window | Power window | OFF / UP / DOWN | - |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (MASTER SWITCH - DRIVER SIDE MOTOR) |
![]() |
Disconnect the power window regulator master switch assembly connector.
Disconnect the power window regulator motor assembly (for driver side) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M2-20 (UP) - I5-10 (UP) | Always | Below 1 Ω |
| M2-15 (DOWN) - I5-7 (DOWN) | Always | Below 1 Ω |
| M2-20 (UP) - Body ground | Always | 10 kΩ or higher |
| M2-15 (DOWN) - Body ground | Always | 10 kΩ or higher |
| I5-10 (UP) - Body ground | Always | 10 kΩ or higher |
| I5-7 (DOWN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY |
Replace the power window regulator master switch assembly (Click here).
| NEXT | |
| 6.CHECK MANUAL UP / DOWN FUNCTION (for Driver Side) |
Check that the driver side door power window moves when the manual up/down function of the power window regulator master switch assembly is operated (Click here).
|
| ||||
| OK | ||
| ||