ANTI-LOCK BRAKE SYSTEM > TC and CG Terminal Circuit |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication DTC is output (Click here).
| Result | Proceed to |
| CAN communication system DTC is output | A |
| CAN communication system DTC is not output | B |
|
| ||||
| A | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (ECM TO DLC3) |
![]() |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| A24-27 (TC) - E10-13 (TC) | Below 1 Ω |
| E10-13 (TC) - Body ground | 10 kΩ or higher |
Connect the connector.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (DLC3 CG CIRCUIT) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| E10-4 (CG) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 4.REPAIR OR REPLACE HARNESS OR CONNECTOR (TC TERMINAL CIRCUIT) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| E10-13 (TC) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||