ENTRY AND START SYSTEM > All Door Entry Lock/Unlock Functions do not Operate, but Wireless Functions Operate |
| 1.READ VALUE USING INTELLIGENT TESTER (ENTRY CANCEL FUNCTION) |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Auto Entry Cancel SW | Entry function cancel / ON or OFF | Mode status displayed | - |
| Result | Proceed to |
| Entry function cancel is OFF | A |
| Entry function cancel is ON | B |
|
| ||||
| A | |
| 2.CHECK WAVE ENVIRONMENT |
Move the electrical key transmitter as described below and perform the operation inspection.
![]() |
Bring the electrical key transmitter near the front door outside handle assembly (for driver side), and perform a front driver door entry lock and unlock operation check.
![]() |
Bring the electrical key transmitter near the front door outside handle assembly (for front passenger side), and perform a front passenger door entry lock and unlock operation check.
![]() |
Bring the electrical key transmitter near the outside electrical key oscillator (for luggage compartment), and perform an entry luggage compartment door open function check.
| Result | Proceed to |
| All operation checks fail | A |
| Some operation checks are normal | B |
|
| ||||
| A | |
| 3.PERFORM KEY DIAGNOSTIC MODE INSPECTION |
![]() |
Diagnostic mode inspection (door electrical key oscillator (for driver side))
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / Utility / Key Communication Check / Overhead + Driver Side.
When the electrical key transmitter is in the position shown in the illustration, check that the wireless door lock buzzer sounds.
![]() |
Diagnostic mode inspection (door electrical key oscillator (for front passenger side))
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / Utility / Key Communication Check / Overhead + Passenger Side.
When the electrical key transmitter is in the position shown in the illustration, check that the wireless door lock buzzer sounds.
![]() |
Diagnostic mode inspection (indoor electrical key oscillator (for front floor))
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / Utility / Key Communication Check / Overhead + Front Room.
When the electrical key transmitter is in the position shown in the illustration, check that the wireless door lock buzzer sounds.
![]() |
Diagnostic mode inspection (indoor electrical key oscillator (for rear floor))
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / Utility / Key Communication Check / Overhead + Rear Room.
When the electrical key transmitter is in the position shown in the illustration, check that the wireless door lock buzzer sounds.
![]() |
Diagnostic mode inspection (indoor electrical key oscillator (for luggage compartment))
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / Utility / Key Communication Check / Overhead + Luggage (inside)
When the electrical key transmitter is held at the same height as the rear bumper upper surface and aligned with the center of the rear of the vehicle, check that the wireless door lock buzzer sounds.
![]() |
Diagnostic mode inspection (outside electrical key oscillator (for luggage compartment))
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry & Start / Utility / Key Communication Check / Overhead + Luggage (outside).
When the electrical key transmitter is in the position shown in the illustration, check that the wireless door lock buzzer sounds.
| Result | Proceed to |
| Wireless door lock buzzer does not sound for all electrical key oscillators. | A |
| Wireless door lock buzzer does not sound only for either door electrical key oscillator. | B |
| Wireless door lock buzzer does not sound only for one indoor electrical key oscillator. | C |
| Wireless door lock buzzer does not sound only for outside electrical key oscillator (for rear side). | D |
| Wireless door lock buzzer sounds for all electrical key oscillators. | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| A | |
| 4.REPLACE ELECTRICAL KEY TRANSMITTER |
Replace the electrical key transmitter.
| NEXT | |
| 5.REGISTER ELECTRICAL KEY TRANSMITTER |
Register the electrical key transmitter.
| NEXT | |
| 6.CHECK ELECTRICAL KEY TRANSMITTER (OPERATION) |
Check that the entry functions operate normally (Click here).
|
| ||||
| OK | ||
| ||