Home › STEERING › STEERING COLUMN › STEERING LOCK SYSTEM

STEERING LOCK SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Perform troubleshooting in accordance with the following flowchart.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT


    3.CHECK AND CLEAR DTCs*

      NEXT


      4.PROBLEM SYMPTOM CONFIRMATION

        Result:
        Result
        Proceed to
        Symptom does not occur.
        A
        Symptom occurs.
        B



      B.
      GO TO STEP 6
      A


      5.SYMPTOM SIMULATION

        NEXT


        6.CHECK CAN COMMUNICATION SYSTEM*
        1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here for LHD or Click here for RHD).

          Result:
          Result
          Proceed to
          CAN communication DTC is not output.
          A
          CAN communication DTC is output (for LHD).
          B
          CAN communication DTC is output (for RHD).
          C



        B.
        GO TO CAN COMMUNICATION SYSTEM (Click here)

        C.
        GO TO CAN COMMUNICATION SYSTEM (Click here)
        A


        7.CHECK LIN COMMUNICATION SYSTEM*
        1. Use the intelligent tester to check if the LIN communication system is functioning normally (Click here).

          Result:
          Result
          Proceed to
          LIN communication DTC is not output.
          A
          LIN communication DTC is output.
          B



        B.
        GO TO LIN COMMUNICATION SYSTEM (Click here)
        A


        8.DTC CHECK*
        1. Check for DTCs (Click here).

          Result:
          Result
          Proceed to
          DTC is output.
          A
          DTC is not output.
          B



        A.
        GO TO STEP 9
        B


        9.PROBLEM SYMPTOMS TABLE

          Result:
          Result
          Proceed to
          Fault is not listed in problem symptoms table.
          A
          Fault is listed in problem symptoms table.
          B



        B.
        GO TO STEP 11
        A


        10.OVERALL ANALYSIS AND TROUBLESHOOTING*
        1. Terminals of ECU (Click here).

        2. Data List / Active Test (Click here).


        NEXT


        11.REPAIR OR REPLACEMENT

          NEXT


          12.CONFIRMATION TEST*

            NEXT

            END