DTC B2278 Engine Switch Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2278 | Communication is abnormal between the main body ECU and engine switch or the engine switch is defective |
|

| 1.READ VALUE USING INTELLIGENT TESTER (START SWITCH) |
Connect the intelligent tester to the DLC3.
Check the Data List for proper functioning of the start switch.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| St SW 1 | Start Switch 1/ON or OFF | ON: Engine switch on (IG) OFF: Engine switch off | - |
| St SW 2 | Start Switch 2/ON or OFF | ON: Engine switch on (IG) OFF: Engine switch off | - |
|
| ||||
| OK | |
| 2.CHECK ENGINE SWITCH CONDITION |
Check the power source mode change.
When the key is inside the vehicle and the shift lever is in the P position, check that pressing the engine switch causes the power source mode to change as follows:
|
| ||||
| OK | ||
| ||
| 3.INSPECT ENGINE SWITCH |
Remove the engine switch (Click here).

Disconnect the switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 7 (SS1) - 5 (GND) | Pushed | Below 1 Ω |
| 2 (SS2) - 5 (GND) | Pushed | Below 1 Ω |
| 7 (SS1) - 5 (GND) | Not pushed | 10 kΩ or higher |
| 2 (SS2) - 5 (GND) | Not pushed | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND) |
Disconnect the E7 ECU connector.

Disconnect the E52 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E52-7 (SS1) - E7-17 (SSW1) | Always | Below 1 Ω |
| E52-2 (SS2) - E7-16 (SSW2) | Always | Below 1 Ω |
| E52-5 (GND) - Body ground | Always | Below 1 Ω |
| E52-7 (SS1) or E7-17 (SSW1) - Body ground | Always | 10 kΩ or higher |
| E52-2 (SS2) or E7-16 (SSW2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||