DTC B2285 Steering Lock Position Signal Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2285 | Cable and LIN information between the main body ECU and the steering lock ECU are inconsistent |
|

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Str Unlock SW | Steering lock condition / ON or OFF | ON: Steering is unlocked (Engine switch on (ACC)) OFF: Steering is locked (Engine switch off) | - |
|
| ||||
| OK | |
| 2.CHECK FOR DTCS |
Clear the DTCs (Click here).
Check for DTC B2285, DTC B2287 and DTC B2786.
| Display (DTC output) | Proceed to |
| "DTC B2285" only | A |
| "DTC B2287" and/or "DTC B2786" | B |
| No DTC | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - STEERING LOCK ECU) |
Disconnect the E7 and E51 ECU connectors.

Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E7-18 (SLP) - E69-4 (SLP1) | Always | Below 1 Ω |
| IR-9 (LIN1) - E69-5 (LIN) | Always | Below 1 Ω |
| E7-18 (SLP) or E69-4 (SLP1) - Body ground | Always | 10 kΩ or higher |
| IR-9 (LIN1) or E69-5 (LIN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK MAIN BODY ECU OPERATION |
After replacing the main body ECU with a normally functioning ECU, check that the engine starts (Click here).
|
| ||||
| OK | ||
| ||