WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Entry and Start System) > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Interview the customer to confirm the trouble (Click here).
| |||||
| 3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM |
Use the intelligent tester to check for normal function of the CAN communication system.
| Result | Proceed to |
| CAN DTC is normal | A |
| CAN DTC is defective (for LHD) | B |
| CAN DTC is defective (for RHD) | C |
|
| ||||
|
| ||||
| |||||
| 4.DTC CHECK |
Check for DTCs and note any codes that are output.
Clear the DTCs.
Recheck for DTCs. Try to prompt the DTC by simulating the original symptom that the DTC suggests.
| Result | Proceed to |
| DTC does not recur | A |
| DTC recurs | B |
|
| ||||
| |||||
| 5.SYMPTOM SIMULATION |
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
If the fault is not listed in the problem symptoms table, proceed to A.
If the fault is listed in the problem symptoms table, proceed to B.
|
| ||||
| |||||
| 7.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM |
Terminals of ECU (Click here)
Data List/Active Test (Click here)
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|