Home › BRAKE › BRAKE CONTROL › FRONT SPEED SENSOR

FRONT SPEED SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SPEED SENSOR


    C144142
  1. Install the front speed sensor to the steering knuckle with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    Prevent foreign matter from attaching to the front speed sensor tip.



    C132781E03
  1. Install the front speed sensor with the 2 bolts and engage the 2 claws.

    Torque:
    Bolt A:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
    Bolt B:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    NOTICE:
    1. Do not twist the wire harness for the front speed sensor when installing the front speed sensor.
    2. The bolt B tightens the brake flexible hose and front speed sensor together. Make sure that the flexible hose is positioned over the front speed sensor.
    3. Install the stopper firmly to the hole in the body.



    C143910E04
  1. Connect the front speed sensor connector and clamp.



2. INSTALL FRONT FENDER LINER (w/o Front Fender Mudguard)


    B149004
  1. Install the front fender liner with the grommet and 5 screws.

  1. Install the bolt and 5 clips.



3. INSTALL FRONT FENDER LINER (w/ Front Fender Mudguard)


    B141646
  1. Install the front fender liner with the grommet and 3 screws.

  1. Install the bolt and 4 clips.



4. INSTALL FRONT FENDER MUDGUARD SUB-ASSEMBLY (w/ Front Fender Mudguard)


    B135467
  1. Install the front fender mudguard sub-assembly with the 3 screws.



5. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



6. CHECK SPEED SENSOR SIGNAL

HINT:
  1. without VSC (Click here)
  2. with VSC (Click here)