ANTI-LOCK BRAKE SYSTEM > TEST MODE PROCEDURE |
| WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK |
![]() |
Release the parking brake.
When the ignition switch is turned to the ON position, check that the ABS warning light comes on for approximately 3 seconds.
| Trouble Area | See procedure |
| ABS warning light (Remains on) |
Click here
|
| ABS warning light circuit (Does not come on) |
Click here
|
| BRAKE warning light (Remains on) |
Click here
|
| BRAKE warning light (Does not come on) |
Click here
|
| SENSOR SIGNAL CHECK USING TEST MODE (SIGNAL CHECK) (INTELLIGENT TESTER) |
![]() |
Procedure to enter Test Mode.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Check that the steering wheel is centered and move the shift lever to the P position (for Automatic Transaxle) or apply the parking brake (Manual Transaxle).
Turn the ignition switch to the ON position.
![]() |
Set the intelligent tester to Test Mode (select "SIGNAL CHECK").
![]() |
Check that the ABS warning light comes on for several seconds and then blinks in test mode.
| Trouble Area | See procedure |
| ABS warning light (Remains on) |
Click here
|
| ABS warning light (Does not come on) |
Click here
|
Check the sensor signal.
Drive the vehicle straight ahead.
Accelerate the vehicle to a speed of 45 km/h (28 mph) or more for several seconds and check that the ABS warning light goes off when the brake pedal is depressed.
Stop the vehicle.
Read the DTC(s) by following the tester screen.
| SENSOR SIGNAL CHECK BY TEST MODE (SIGNAL CHECK) (SST CHECK WIRE) |
Procedure for Test Mode.
Turn the ignition switch off.
Check that the steering wheel is centered and move the shift lever to the P position (Automatic Transaxle) or apply the parking brake (Manual Transaxle).
![]() |
Using SST, connect terminals TS and CG of the DLC3.
Turn the ignition switch to the ON position.
![]() |
Check that the ABS warning light comes on for several seconds and then blinks in Test Mode.
| Trouble Area | See procedure |
| TS and CG terminal circuit |
Click here
|
| ABS warning light circuit (Remains on) |
Click here
|
| ABS warning light circuit (Does not come on) |
Click here
|
Check the sensor signal.
Drive the vehicle straight ahead.
Accelerate the vehicle to a speed of 45 km/h (28 mph) or more for several seconds and check that the ABS warning light goes off when the brake pedal is depressed.
Stop the vehicle.
![]() |
Using SST, connect terminals TC and CG of the DLC3.
Count the number of blinks of the ABS warning light.

After performing the check, disconnect the SST from terminals TS and CG, and TC and CG of the DLC3, and turn the ignition switch off.
Turn the ignition switch to the ON position to cancel the test mode.
| DTC OF TEST MODE (SIGNAL CHECK) FUNCTION (Procedure "A") |
| Code No. | Diagnosis | Trouble Area |
| C1271/71 | Low output signal of front speed sensor RH |
|
| C1272/72 | Low output signal of front speed sensor LH |
|
| C1273/73 | Low output signal of rear speed sensor RH |
|
| C1274/74 | Low output signal of rear speed sensor LH |
|
| C1275/75 | Abnormal change in output signal of front speed sensor RH |
|
| C1276/76 | Abnormal change in output signal of front speed sensor LH |
|
| C1277/77 | Abnormal change in output signal of rear speed sensor RH |
|
| C1278/78 | Abnormal change in output signal of rear speed sensor LH |
|