Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only)

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on Driver Door Window Only) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the power window control system.
  2. The intelligent tester should be used in steps 3 and 5.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK

      NEXT


      3.CHECK COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM
      1. Use the intelligent tester, inspect the LIN communication function to ensure there are no malfunctions in the communication system.

        Result:
        Result
        Proceed to
        No DTCs output
        A
        DTCs output
        B



      B.
      GO TO DIAGNOSIS TROUBLE CODE CHART
      A


      4.PROBLEM SYMPTOMS TABLE

        HINT:
        Click here.


      NEXT


      5.OVERALL ANALYSIS AND TROUBLESHOOTING
      1. Data list/Active test

        HINT:
        Click here.

      2. Circuit inspection

      3. Terminal of ECU

        HINT:
        Click here.


      NEXT


      6.ADJUST, REPAIR OR REPLACE

        NEXT


        7.RESET POWER WINDOW MOTOR

          HINT:
          Click here.


        NEXT

        END