AUDIO AND VISUAL SYSTEM > Radio Broadcast cannot be Received or Poor Reception |
| 1.CHECK RADIO RECEIVER |
Check the radio automatic station search function.
Check the radio automatic station search function by activating it.
| Result | Proceed to |
| Automatic station function stops on a station | A |
| Automatic station search function does not stop | B |
|
| ||||
| A | ||
| ||
| 2.CHECK OPTIONAL COMPONENTS |
Check for optional components (sunshade film, telephone antenna, etc.).
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
| Result | Proceed to |
| Optional components are installed | A |
| Optional components are not installed | B |
|
| ||||
| A | ||
| ||
| 3.CHECK RADIO RECEIVER |
![]() ![]() |
Preparation for check
Remove the antenna plug from the radio receiver.
Check for noise
Turn the ignition switch to ACC with the radio receiver connector connected.
Turn the radio on and tune into AM mode.
Place a screwdriver, thin wire or other metal object on the radio receiver antenna jack and check that noise can be heard from the speaker.
| *1 | Component without harness connected (Radio Receiver*3) |
| *2 | Component without harness connected (Radio Receiver*4) |
|
| ||||
| OK | |
| 4.CHECK GLASS ANTENNA |
![]() |
Check for continuity of the antenna.
|
| ||||
| OK | |
| 5.CONFIRM MODEL |
| Result | Proceed to |
| w/o Microphone | A |
| w/ Microphone | B |
|
| ||||
| A | |
| 6.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - ANTENNA AMPLIFIER) |
![]() |
Disconnect the radio receiver and antenna amplifier connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F6-8 (ANT) - F15-1 (B) | Always | Below 1 Ω |
| F6-8 (ANT) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Radio Receiver) |
| *2 | Front view of wire harness connector (to Antenna Amplifier) |
|
| ||||
| OK | |
| 7.INSPECT RADIO RECEIVER |
![]() |
Reconnect the F15 connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K-2 (+B) - Body ground | Ignition switch ACC Radio switch on | 11 to 14 V |
| F15-1 (B) - Body ground | Ignition switch ACC Radio switch on | 11 to 14 V |
| *1 | Component without harness connected (Radio Receiver)*3 |
| *2 | Front view of wire harness connector (to Antenna Amplifier)*4 |
|
| ||||
| OK | |
| 8.CHECK ANTENNA CORD |
Remove the antenna plug of the radio receiver and antenna.
Measure the resistance between the antenna and radio receiver to check for an open circuit in the antenna cord.
Measure the resistance between the antenna cord and body ground to check for a short circuit in the antenna cord.
|
| ||||
| OK | |
| 9.REPLACE AMPLIFIER ANTENNA |
Replace the amplifier antenna and check if radio broadcasts can be received normally (Click here).
|
| ||||
| OK | ||
| ||