POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows) > Key-off Operation Function Operates even if Operating Conditions are not Satisfied |
| 1.CHECK MANUAL UP / DOWN FUNCTION |
Check that the manual up/down function using the power window regulator master switch assembly and power window regulator switch assembly can operate all the power windows (Click here).
|
| ||||
| OK | |
| 2.CHECK REMOTE UP / DOWN FUNCTION |
Check that the remote up/down function using the power window regulator master switch assembly operates the power windows (Click here).
|
| ||||
| OK | |
| 3.CHECK OPERATION FUNCTION AFTER IGNITION SWITCH IS TURNED OFF |
Check the power window operation function after the ignition switch is turned off.
| Result | Proceed to |
| When power window can still be operated even after opening driver door or front passenger door within approximately 45 seconds of ignition switch being turned off | A |
| When power window can still be operated even after approximately 45 seconds have elapsed after ignition switch is turned off (for All Doors) | B |
| When power window can still be operated even after approximately 45 seconds have elapsed after ignition switch is turned off (for Driver Side, Front Passenger Side, Rear LH Side or Rear RH Side)) | C* |
|
| ||||
|
| ||||
| A | |
| 4.READ VALUE USING INTELLIGENT TESTER (Main Body) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| D Door Courtesy SW | Driver side door courtesy switch signal / ON or OFF | ON: Driver side door open OFF: Driver side door closed | - |
| P Door Courtesy SW | Front passenger side door courtesy switch signal / ON or OFF | ON: Front passenger side door open OFF: Front passenger side door closed | - |
|
| ||||
| OK | ||
| ||