DIFFERENTIAL OIL SEAL > INSTALLATION |
| 1. INSTALL TRANSAXLE CASE OIL SEAL |
![]() |
Using SST and a hammer, install a new oil seal to the transaxle case.
Coat the lip of the oil seal with MP grease.
| 2. INSTALL FRONT TRANSAXLE CASE OIL SEAL |
![]() |
Using SST and a hammer, install a new oil seal to the transaxle housing.
Coat the lip of the oil seal with MP grease.
| 3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Coat the spline of the inboard joint shaft assembly with ATF.
Align the shaft splines and install the drive shaft assembly LH with a brass bar and hammer.
| 4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH |
![]() |
Coat the spline of the inboard joint shaft assembly with ATF.
Install the front drive shaft the assembly RH.
Using a screwdriver, install a new bearing bracket hole snap ring.
Install a new bolt.
| 5. INSTALL FRONT AXLE ASSEMBLY LH |
![]() |
Align the matchmarks and install the front drive shaft assembly to the front axle hub sub-assembly.
| 6. INSTALL FRONT AXLE ASSEMBLY RH |
| 7. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM LH |
![]() |
Install the lower ball joint to the front suspension lower No. 1 arm with the bolt and 2 nuts.
| 8. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM RH |
| 9. INSTALL TIE ROD ASSEMBLY LH |
Install the tie rod end sub-assembly to the steering knuckle with the nut.
Install a new cotter pin.
| 10. INSTALL TIE ROD ASSEMBLY RH |
| 11. INSTALL FRONT SPEED SENSOR LH |
![]() |
Install the front speed sensor to the steering knuckle with the bolt.
![]() |
Install the flexible hose and the speed sensor to the shock absorber with the bolt and set the sensor clip on the knuckle.
| 12. INSTALL FRONT SPEED SENSOR RH |
| 13. INSTALL FRONT STABILIZER LINK ASSEMBLY LH |
![]() |
Install the stabilizer link assembly with the nut.
| 14. INSTALL FRONT STABILIZER LINK ASSEMBLY RH |
| 15. INSTALL FRONT AXLE HUB NUT LH |
Clean the threaded parts on the drive shaft and front axle hub nut using a non-residue solvent.
![]() |
Using a socket wrench (30 mm), install a new axle hub nut.
Using a chisel and hammer, stake the front axle hub nut.
| 16. INSTALL FRONT AXLE HUB NUT RH |
| 17. INSTALL FRONT WHEELS |
| 18. ADD AUTOMATIC TRANSAXLE FLUID |
| 19. ADJUST FRONT WHEEL ALIGNMENT |
| 20. CHECK ABS SPEED SENSOR SIGNAL |
ABS: (Click here)
VSC: (Click here)