ANTI-LOCK BRAKE SYSTEM > ABS Warning Light Remains ON |

| 1.INSPECT CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Condition | Proceed to |
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
|
| ||||
| A | |
| 2.CHECK SKID CONTROL ECU CONNECTOR SECURELY CONNECTED |
Check if the skid control ECU connector is connected.
|
| ||||
| OK | |
| 3.CHECK BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 4.INSPECT SKID CONTROL ECU CONNECTOR (IG1 TERMINAL VOLTAGE) |
![]() |
Disconnect the skid control ECU connector.
Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A25-18 (IG1) - Body ground | Ignition switch on | 10 to 14 V |
|
| ||||
| OK | |
| 5.INSPECT SKID CONTROL ECU CONNECTOR (GND TERMINAL CONTINUITY) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| A25-4 (GND1) - Body ground | Below 1 Ω |
| A25-1 (GND2) - Body ground | Below 1 Ω |
Connect the connector.
|
| ||||
| OK | |
| 6.INSPECT COMBINATION METER ASSEMBLY |
Connect the intelligent tester to the DLC3.
Select the "Active Test" on the tester (Click here).
| Tester Display | Test Part/Control Range | Diagnostic Note |
| ABS Warning Lamp | Turn ABS warning light ON / OFF | Observe combination meter |
Check the ABS warning light operation.
| Condition | Proceed to |
| OK | A |
| OK (When troubleshooting in accordance with the PROBLEM SYMPTOMS TABLE) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||