Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > Brake Warning Light does not Come ON

for Preparation Click here


WIRING DIAGRAM


C136504E03


C141357E01


INSPECTION PROCEDURE

HINT:
Check the condition of each related circuit connector before troubleshooting (Click here).

1.INSPECT CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:

    Condition
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B



B
REPAIR CAN COMMUNICATION SYSTEM (Click here)
A


2.INSPECT BRAKE WARNING LIGHT

HINT:
When disconnecting the skid control ECU connector, the brake warning light comes on.

  1. Turn the ignition switch off.

  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to the ON position.

  1. Check that the brake warning light comes on.

    OK:
    The brake warning light comes on.



NG
Go to step 3
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

3.INSPECT COMBINATION METER ASSEMBLY
  1. Connect the intelligent tester to the DLC3.

  1. Select the "Active Test" on the tester (Click here).

    Active Test: ABS 
    Tester Display
    Test Part/Control Range
    Diagnostic Note
    BRAKE WARN LIGHT
    Turn brake warning light ON / OFF
    Observe combination meter

  1. Check the ABS warning light operation.

    OK:
    The BRAKE warning light turns on or off in accordance with the intelligent tester.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)