DTC B2273 Ignition 2 Monitor Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2273 | IG2 relay actuation circuit inside main body ECU or other related circuit is malfunctioning |
|

| 1.READ VALUE USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Body / Data List.
Read the Data List according to the displays on the tester.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| IG2 Relay Mon 1 | Status of IG2 relay monitor (outer) / ON or OFF | ON: Engine switch on (IG) (IG2 relay is ON) OFF: Engine switch off (IG2 relay is OFF) | - |
|
| ||||
| OK | |
| 2.CHECK ENGINE SWITCH CONDITION |
Check the power source mode change.
When the key is inside the vehicle and the shift lever is in the P position, check that pressing the engine switch causes the power source mode to change as follows:
|
| ||||
| OK | |
| 3.INSPECT RELAY (IG2 RELAY) |
![]() |
Remove the IG2 relay from the engine room R/B.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | When battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
| 3 - 5 | When battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (ENGINE ROOM R/B - MAIN BODY ECU AND BODY GROUND) |
Remove the IG2 relay from the engine room R/B.

Disconnect the E6 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Engine Room R/B IG2 relay terminal 1 - E6-11 (IG2D) | Always | Below 1 Ω |
| Engine Room R/B IG2 relay terminal 2 - Body ground | Always | Below 1 Ω |
| E6-11 (IG2D) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||