NAVIGATION SYSTEM > Reverse Signal Circuit |

| 1.INSPECT NAVIGATION RECEIVER ASSEMBLY |
![]() |
Disconnect the navigation receiver assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F25-5 (REV) - Body ground | Ignition switch ON Shift lever in R | 11 to 14 V |
| F25-5 (REV) - Body ground | Ignition switch ON Shift lever in any position except R | Below 1 V |
| *1 | Front view of wire harness connector (to Navigation Receiver Assembly) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH) |
![]() |
Disconnect the navigation receiver assembly connector.
![]() |
Disconnect the park/neutral position switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| F25-5 (REV) - C1-1 (RL)*3, C1-2 (RL)*4 | Always | Below 1 Ω |
| F25-5 (REV) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Navigation Receiver Assembly) |
| *2 | Front view of wire harness connector (to Park/Neutral Position Switch) |
| *3 | for 2AZ-FE |
| *4 | for 2GR-FE |
|
| ||||
| NG | |
| 3.CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - BATTERY) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C1-2 (RB)*2, C1-1 (RB)*3 - Body ground | Ignition switch ON | 11 to 14 V |
| Result | Proceed to |
| OK | A |
| NG (for U660E) | B |
| NG (for U250E) | C |
| *1 | Front view of wire harness connector (to Park/Neutral Position Switch) |
| *2 | for 2AZ-FE |
| *3 | for 2GR-FE |
|
| ||||
|
| ||||
| A | ||
| ||