Home › ENGINE · 2GR-FE › STARTING › ENTRY AND START SYSTEM

DTC    B2288    Steering Lock Signal Circuit Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when the main body ECU cannot detect the unlock condition of the steering lock within a specified time.

HINT:
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.


DTC No.
DTC Detection Condition
Trouble Area
B2288
After turning engine switch from off to on (IG), the steering wheel does not unlock for a certain period of time (ECU unlocks steering wheel only when it receives an unlock signal from LIN communication and cable)
  1. Main body ECU
  2. Steering lock ECU
  3. Wire harness or connector

WIRING DIAGRAM


B112452E62


INSPECTION PROCEDURE

1.CHECK FOR DTCS
  1. Delete the DTCs (Click here).

  1. After all DTCs are cleared, check if the trouble occurs again 5 seconds after the engine switch is turned on (IG).

  1. Check for DTCs again.

    OK:
    DTC B2785, DTC B2287 and DTC B2781 are not output.

    HINT:
    1. If DTC B2785 is output (Click here).
    2. If DTC B2287 is output (Click here).
    3. If DTC B2271 is output (Click here).



NG
GO TO DTC CHART
OK


2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - STEERING LOCK ECU)


  1. Disconnect the E7 and E69 ECU connectors


    B137999E06

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E7-18 (SLP) - E69-4 (SLP1)
    Always
    Below 1 Ω
    E7-18 (SLP) or E69-4 (SLP1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK MAIN BODY ECU OPERATION
  1. After replacing the main body ECU with a normally functioning ECU, check that the steering lock/unlock function operates normally.

    OK:
    Steering lock/unlock function operates normally.

    HINT:
    If steering lock/unlock function does not operate, refer to PROBLEM SYMPTOMS TABLE of the electrical steering lock (steering wheel cannot be unlocked) (Click here).



NG
GO TO ELECTRIC STEERING LOCK
OK

END (MAIN BODY ECU WAS DEFECTIVE)