DTC C1249/49 Open in Stop Light Switch Circuit |
| DTC No. | DTC Detecting Condition | Trouble Area |
| C1249/49 | Stop light switch circuit is open, and stop light switch voltage is 40% or more and less than 67% of the battery voltage. |
|

| 1.CHECK STOP LIGHT SWITCH OPERATION (STOP LIGHT SWITCH CIRCUIT) |
Check that the stop lights come on when the brake pedal is depressed and goes off when the brake pedal is released.
| Pedal Condition | Illumination Condition |
| Brake pedal depressed | ON |
| Brake pedal released | OFF |
|
| ||||
| OK | |
| 2.INSPECT SKID CONTROL ECU CONNECTOR (STP TERMINAL) |
![]() |
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A25-20 (STP) - Body ground | Brake pedal depressed | 8 to 14 V |
| A25-20 (STP) - Body ground | Brake pedal released | Below 4.0 V |
|
| ||||
| OK | |
| 3.INSPECT SKID CONTROL ECU CONNECTOR (GND TERMINAL CONTINUITY) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| A25-4 (GND1) - Body ground | Below 1 Ω |
| A25-1 (GND2) - Body ground | Below 1 Ω |
Connect the connector.
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Depress the brake pedal several times to test the stop light circuit.
Check if the same DTC is recorded (Click here).
| Condition | Proceed to |
| DTC is not output | A |
| DTC is output (When troubleshooting in accordance with the DTC CHART) | B |
| DTC is output (When troubleshooting in accordance with the PROBLEM SYMPTOMS TABLE) | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 5.INSPECT STOP LIGHT SWITCH ASSEMBLY (POWER SOURCE TERMINAL VOLTAGE) |
![]() |
Disconnect the stop light switch connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-2 - Body ground | Always | 10 to 14 V |
|
| ||||
| OK | |
| 6.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Switch pin free | 1 - 2 | Below 1 Ω |
| Switch pin pushed in | 1 - 2 | 10 kΩ or higher |
|
| ||||
| OK | |
| 7.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH TO SKID CONTROL ECU) |
![]() |
Disconnect the stop light switch connector and skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| A25-20 (STP) - A19-1 (STP) | Below 1 Ω |
Connect the connector.
|
| ||||
| OK | ||
| ||