Home › Engine / Hybrid System › 2AR-FE ENGINE CONTROL › ECM
RM19V0EQ _51 Engine / Hybrid System _014573 2AR-FE ENGINE CONTROL _0073914 ECM A

2AR-FE ENGINE CONTROL  ECM  INSTALLATION  


PROCEDURE

Hide 89667E 1.INSTALL NO. 1 ECM BRACKET

a.

Install the No.1 ECM bracket with the nut.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


b.

Connect the wire harness clamp.


c.
A254783

Connect the wire harness clamp.


d.

Install the nut.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 89661 2.INSTALL ECM

a.

Install the No.2 ECM bracket to the ECM with the 2 screws.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


b.
A254792N03
2.49,0.74 2.615,0.896 0.125,0.156 10 A 2.396,1.198 2.521,1.354 0.125,0.156 10 B

Temporarily install the screw (B).


c.

Install the ECM with the nut.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


d.

Install the screw (A).

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


e.

Tighten the screw (B).

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


f.
A264409

Connect the 2 ECM connectors and lower the 2 levers.

NOTICE:
·

When connecting the connectors, make sure that dirt, water or other foreign matter does not become stuck between the connectors and other parts.

·

Make sure that the 2 levers are securely locked.




g.

Connect the 2 wire harness clamps.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION